Flashing & Trim
Explore Vantell building envelope products through the complete system hierarchy.
Flashing & Trim
Pipe Flashing
Pipe Flashing is made of aluminum and galvanized steel. The product model start with G is galvanized steel with high zinc layer. The product model start with A is aluminum.
View product ↗
Double layer siding outside corner flashing
A traditional outside corner without the joints, caulked seams and nail holes that butted 1x4s require.
View product ↗
Double layer siding inside corner flashing
Design authentically duplicates the look of a wood corner piece without the maintenance headaches. Eliminates wood inside corner piece that will split/rot over time.
View product ↗
Single layer siding upper flashing
Provides a clean finish at openings, edges of panels or planks and at material transitions.
View product ↗
Single layer siding below flashing
Starter/bottom course for both vertical and lap siding. Provides ease-of-installation with correct angle.
View product ↗
Siding "L" Transtion Trim flashing
Design for facade / soffit transition with an appearance complementary to the vertical reveal.
View product ↗
Window/Head Flashing
Provides an easy to install and long-lasting method of minimizing water penetration. Used over window trim, band boards, panel intersections, and other vertical surfaces.
View product ↗
Angle/Base Flashing
Efficient wall to roof application. Protects against leaks at walls and chimneys to roof connections.
View product ↗
Window Flashing
Galvanized Window Flashing provides an inexpensive and easy to install method of stopping water penetration behind siding.
View product ↗
Z Flashing
Z flashing provide a cost-effective and convenient installation method to prevent water enter clapboard, material is 0.25mm galvanized sheet, American standard high zinc layer.
View product ↗
Kick Out Flashing
Kick out flashing is used where a lower roofline terminates against a vertical wall. The kick out is installed above the rain gutter or drip edge where the roof meets a vertical wall. It kicks out rain water and diverts
View product ↗
Proline Plank Flash
Best practices solution tested and proven to reduce moisture penetration behind the joint where two planks butt together and drain water over the top edge of the last full course of siding. The design allows for quick an
View product ↗
Step Flashing
Model： Step Flashing FS448/FS6610 Technical Data: It has several applications. including chimney and skylight water retaining, pre-cut, easy to use, material is 0.25mm galvanized sheet, American standard high zinc layer.
View product ↗